How to avoid glass block in glass drying machine?
Operation method of glass drying machine:
1. Turn on the power control switch, and the power indicator light is on. The voltage should be between 380V and 400V, indicating that the power supply has been switched on.
2. 2. Press the "heating", "water pump" and "rotation" buttons respectively, there is heat temperature at the glass outlet; the water flows out evenly at the water tank at the lower part of the machine; all the rotating rollers run in the body, the fan blows and the chain rotates Even and stable, no abnormal noise, 10 minutes of no-load operation, after everything is normal, turn off the water spray pipe switch on the suction roller, and then put the glass to be cleaned into the cleaning. But how should we avoid some emergency situations such as block the glass?
We can do prevention from the following aspects:
1. Do not put glass that exceeds the limit thickness of the washing machine.
2. When inserting the film, the distance between the glass should be large enough.
3. Don't clean the glass that is smaller than the specified size of the equipment first, and when cleaning those glasses that meet the regulations but the size is still very small, someone must guard the air knife and roller brush of the cleaning machine, and find that the glass is stuck or abnormal. Stop immediately to eliminate.
4. When cleaning narrow and long glass or glass with small size, the long side should be placed along the direction of advance.
5. The angle of the air knife should be adjusted to meet the requirements, the blowing direction should not be too far into the film, and the air knife should not be moved randomly.
